Introduction
Sigfox has a global coverage network, operating in unlicensed bands worldwide, with radio frequencies ranging from 862 to 928 MHz. Using unlicensed bands enable devices to send their data to the cloud while using little power, at very low cost.
ADS-260 is a battery powered Sigfox network end node for low voltage, low power sensors. The unit is available for the RC1 (868 to 869 MHz), RC2 and RC4 (902 to 928 MHz) bands. It incorporates one input, configurable as analog, or pulse counter input and multiple excitation options for powering measuring transducers. Dedicated digital interfaces support the SDI-12 and MODBUS communication protocols. A D-size Lithium Thionyl battery can provide autonomous operation for over 10 years.
SDI-12 Serial Bus
SDI-12 is an asynchronous, ASCII, serial communications protocol that was developed for intelligent sensor instruments that typically monitor environmental, structural engineering and precision agriculture data. The communication is achieved by digital communications. The addressing system allows data recorder to communicate with several microprocessor-based sensors over a single line. ADS-260 is compliant to the SDI-12 Standard Version 1.2 and supports extended commands for sensor configuration, in terminal mode. ADS-260 can collect data from several SDI-12 sensors for a total amount of 8 measurement channels.
RS-485, MODBUS
ADS-260 supports acquisition from sensors with RS-485 interface, using the popular MODBUS protocol (RTU & ASCII). Up to 8 measurement channels from several sensors are supported.
Transducer excitation
The unit provides multiple excitation options for measuring transducers.
Applications
- Weather conditions & environmental monitoring
- Water/wastewater level & quality
- Structural engineering
- Precision Agriculture
- Smart City
- Oil & Gas
- Building Management
- Factory Automation
- Power Grid
Coverage
The countries currently supported in RC1, RC2 and RC4 zones are:
RC1: Europe: Austria, Belgium, Bulgaria, Croatia, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, United Kingdom.
Overseas France: French Guiana, French Polynesia, Guadeloupe, Martinique, Mayotte, New Caledonia, Reunion.
Middle East and Africa: Botswana, Kenya, Mauritius, Nigeria, Oman, Senegal, South Africa, Swaziland, United Arab Emirates.
RC2: Brazil, Canada, Mexico, Puerto Rico, USA.
RC4: Latin America: Argentina, Chile, Colombia, Costa Rica, Ecuador, El Salvador, Guatemala, Honduras, Nicaragua, Panama, Peru, Trinidad & Tobago, Uruguay.
Asia Pacific: Australia, Hong Kong, Indonesia, Malaysia, New Zealand, Singapore, Taiwan, Thailand.
Application Example using Losant Enterprise IoT Platform
Two ADS-260 devices are installed at our premises operating 24/7. They powers, samples and transmits every 10 minutes measurements from the following sensors,
- An analogue devices TMP36 temperature sensor measuring -20..+50oC
The ADS-260 is powered by one D size lithium Saft LSH20 battery that will allow it to to operate for more than 2.5 years.
View he application Dashboard at,
https://infinite-sigfox-greece.onlosant.com/
Username: guest@infinite.com
Password: Infinite
Ordering Codes
Code | Description |
---|---|
ADS-260-82 | SIGFOX End node, RC1 865-870 MHz Band (ETSI) |
ADS-260-92 | SIGFOX End node, RC2, RC4 902-928 MHz Band (FCC) |
Specifications
Power supply | |
---|---|
Supply voltage | Internal: 3.6V, 13Ah Lithium Thionyl battery (Saft LSH-20 recommended) External: 5 VDC, regulated |
Consumption | |
Stand by | 18μA max.at 3.6V |
Communication | 865-870 MHz Band: Receive: average 31mA, Transmit: average 59mA, 902-928 MHz Band: Receive: average 31mA, Transmit: average 292mA. |
Measurement | Up to 1A at 3.6V (according to sensor supply requirements) |
Processing unit | |
System controller | Ultra low power ARM 7 MCU |
Configuration memory | 16 KByte EEPROM |
Configurable Input (IN1) | |
Digital input | 1, dry contact, 0-30VDC |
Pulse counter | 1, 2KHz. |
Analog input | 1, Range: 0-1V, 12 bit resolution. |
Serial Bus features & options | |
SDI-12 | 8 channels, up to 3 sensors, Support of extended commands in Terminal mode |
RS-485, MODBUS | 8 channels, up to 3 sensors, MODBUS RTU & ASCII protocol |
RS-485 | Sensors with RS-485 interface and proprietary protocol (OEM versions only) |
Sensor excitation | |
Output 1 | 12VDC/250mA |
Output 2 | 5VDC/200mA |
Communication | |
865-870 MHz Band (ETSI) | Input/output impedance 50Ω, Uplink data rate (TX) 100 bps, Sensitivity -124 dBm, Max output power +14 dBm |
902-928 MHz Band (FCC) | Input/output impedance 50Ω, Uplink data rate (TX) 600 bps, Sensitivity -124 dBm, Max output power +24 dBm |
Antenna connector | SMA Jack |
Serial interface | USB, up to 115 kBit/s |
Other | |
Temperature | -40°…65°C, operating |
Indications | LED, Operation status |
Dimensions | 124 x 79.5 x 70 mm (with cable gland) |
Protection | IP66, IP68 |
Weight | 0.3 kg (without battery) |
Document | File |
---|---|
ADS-260 Aerinos Sigfox Datasheet v1.x | ADS-260 Aerinos Sigfox Datasheet v1.1 |
Document | File |
---|---|
ADS-260 User Manual v1.x | Contact us for the latest document |
LSH-20, D-size, Lithium-thionyl battery | LSH20.pdf |
WA Manager User Manual v10.x | WA Manager User Manual v10.x |
Name | File |
---|---|
WA Manager configuration utility v10.67 | WA Manager v10.67 |
Application Documents
Name | File |
How to build a Sigfox IoT telemetry application | Case Study ADS-260_How to build a Sigfox IoT telemetry application v1.4,pdf |
Presentation Autonomous RTUs | Autonomous RTUs v2 |
Presentation IoT for Water Telemetry | IoT for Water Telemetry v2.pdf |
Presentation IoT for Precision Agriculture | IoT for Precision Agriculture v6.pdf |
Presentation IoT for Structural Engineering & Rail Systems | IoT for Structural Eng & Rail Systems v1.pdf |
Latest News
Infinite participation in the Itron Marketplace
Infinite is proud to participate in the Itron Partner Solution …
Infinite releases Aerinos ADS-300 NBIoT, LTE-M end node
Infinite is proud to announce the release of the ADS-300 …
Infinite partners with Losant
Infinite is proud to announce the partnership with Losant Enterprise …
Infinite releases new IOs and Android WaT applications v1.3.1
Infinite is proud to announce the release of a new …
Emergency Warning Board
Emergency Warning Board, based on BSC-50E
Courtesy of Yeltech, UK
https://yeltech.com/
Rail Line Temperature Monitoring
Rail line temperature monitoring, based on BSC-50D
Courtesy of Yeltech, UK
https://yeltech.com/
ADS-410 Itron Gen5 node
ADS-410 Showcased at Distributech 2019 at the Itron booth.
Courtesy of Itron , USA
https://www.itron.com/